Analisis Kualitas Bahan Bakar Marine Fuel Oil (MFO) Hasil Separasi pada Pembangkit Listrik Tenaga Diesel PT. Cogindo Daya Bersama – Kupang NTT
-
Filisianus Lende(1)
Program Studi Teknik Mesin, Fakultas Sains dan Teknik Universitas Nusa Cendana
-
Ishak S. Limbong(2*)
Program Studi Teknik Mesin, Fakultas Sains dan Teknik Universitas Nusa Cendana
-
Wenseslaus Bunganaen(3)
Program Studi Teknik Mesin, Fakultas Sains dan Teknik Universitas Nusa Cendana
(*) Corresponding Author
Abstract
Analysis of the quality of marine fuel oil (MFO) from the separation process at the diesel power plant of PT. Cogindo DayaBersama Tenau is needed to increase the calorific value of the MFO. Tests were conducted using a bomb calorimeter to calculate the energy capacity value, a centrifuge to determine the sediment volume, and observations made using a microscope to investigate the particles in the MFO. The test results (using a bomb calorimeter) showed that the energy value of the MFO that had not been separated and that had been separated was 7,776 cal/g and 8,298 cal/g (6.71% greater). The test results (using a centrifuge) also showed that the average sediment volume value of the MFO fuel that had not been separated and that had been separated was 6,273 cm³ (96.67% sediment) and 0.216 cm³ (3.33% sediment). Microscope observations showed that separated MFO was superior to unseparated MFO, as it contained more particles than unseparated MFO. These results indicate that the MFO separation process at PT Cogindo Daya Bersama has been carried out effectively
Downloads
References
[2]. H. Agung, “Analisis Penyebab Tercampurya Minyak Lumas Dengan Bahan Bakar Pada Karter Mesin Disel Generator Di Mv. Kt02.” Politeknik Ilmu Pelayaran Semarang, 2020.
[3]. M. Masrianto, “Studi Tentang Proses Pembangkitan Listrik Tenaga Diesel (PLTD) di PT. PLN (Persero) Wilayah Sulselrabar Sektor Tello Makassar.” Universitas Negeri Makassar, 2021.
[4]. P. Nandika, “Perawatan Dan Pengoperasian Fuel Oil (Fo) Purifier Dalam Meningkatkan Mutu Bahan Bakar Di Km. Ss Barakuda Pt. Citra Bahari Shipyard Tegal,” Karya Tulis, 2019.
[5]. G. R. H. H. Salsabila, “Proses Treatment Marine Fuel Oil (Mfo) Sebagai Bahan Bakar Pada Mesin Diesel,” J. Kompetensi Tek., Vol. 11, No. 1, Pp. 30–35, 2019.
[6]. D.-D. T. M. Daryanto, “Jakarta: Pt,” Rineka Cipta, 2007.
[7]. P. V. Maanen, “Motor Diesel Kapal,” Diesel Kapal, Vol. 1, P. 10, 2003.
[8]. H. E. F. Manurung And Y. Saptini, “Penentuan Suhu, Waktu, Dan Kecepatan Putaran Yang Optimal Pada Proses Sentrifugasi Pengujian Kadar Gel Berdasarkan Sni 8385:2017,” Pertem. Dan Present. Ilm. Stand., Vol. 2020, Pp. 141–146, 2021, Doi: 10.31153/Ppis.2020.75.
[9]. A. R. I. A. I Wayan, “Analisis Pengaruh Gravity Disc Dan Perawatan Terhadap Kinerja Fo Purifier (Dengan Metode Spss) Dan Strategi Optimalisasi Kinerja Fo Purifier Di Kapal Mt. Erowati (Dengan Metode Swot).” Politeknik Ilmu Pelayaran Semarang, 2018.
[10]. M. D. Puteri, “Uji Nilai Kalor Bahan Bakar Solar Terhadap Perubahan Suhu Dan Pengadukan Menggunakan Metode Kalorimeter Bom (The Experiment Of Diesel Fuel Calorie Toward Change The Temperature And Stirring By Using Calorimeter Bomb Method).” Undip, 2016.
Copyright (c) 2025 LONTAR Jurnal Teknik Mesin Undana
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
