STUDY OF BLADE OVERLAP VARIATION ON THE POWER COEFFICIENT, TORQUE, AND TSR OF A SAVONIUS TURBINE FOR THE LOW-WIND-SPEED REGION OF NTT

  • Nur Afni(1)
    Nusa Cendana University
  • Sudirman Syam(2*)
    Universitas Nusa Cendana http://orcid.org/0000-0001-8690-2037
  • Sri Kurniati(3)
    Nusa Cendana University
  • (*) Corresponding Author
Keywords: Savonius turbine; blade overlap; power coefficient; torque; tip speed ratio

Abstract

The utilization of wind energy in East Nusa Tenggara (NTT), which has low wind speeds (2–7 m/s), requires a turbine capable of operating under low-flow conditions. The Savonius turbine is a suitable solution because of its good self-starting capability and simple construction. This study aims to analyze the effect of blade overlap air-gap variations on the performance of a U-type Savonius turbine, including torque, power coefficient (Cp), and tip speed ratio (TSR). An experimental method was conducted using a wind tunnel and blower as an artificial wind source. Three overlap gap variations tested were 5 mm, 10 mm, and 15 mm, with wind speeds ranging from 4 m/s to 12 m/s under mechanical loading. Data collection was repeated three times for each test condition. The results show that the overlap gap variation significantly affects turbine performance. The 5 mm overlap configuration consistently produced the best performance with a maximum torque of 0.0027 N·m at 12 m/s wind speed, the highest power coefficient of 0.046 at 9 m/s, and the highest TSR of 0.190 at 10 m/s. The 5 mm overlap configuration is recommended for application in regions with low to moderate wind speeds (4–8 m/s) such as NTT.

Downloads

Download data is not yet available.

Author Biographies

Nur Afni, Nusa Cendana University

Electrical Engineering Study Program, Nusa Cendana University, Indonesia

Sri Kurniati, Nusa Cendana University

Electrical Engineering Study Program, Nusa Cendana University, Indonesia

References

M. Z. Jacobson, M. A. Delucchi, M. A. Cameron, and B. V. Mathiesen, “Matching demand with supply at low cost in 139 countries among 20 world regions with 100% intermittent wind, water, and sunlight (WWS) for all purposes,” Renew. Energy, vol. 119, pp. 825–847, 2018, doi: https://doi.org/10.1016/j.renene.2018.02.009.

IRENA, World Energy Transitions Outlook 2024: 1.5 °C Pathway. Abu Dhabi, United Arab Emirates: International Renewable Energy Agency, 2024.

N. A. Pambudi et al., “The future of wind power plants in Indonesia: Potential, challenges, and policies,” Sustainability, vol. 17, no. 1312, pp. 1–21, 2025, doi: https://doi.org/10.3390/su17031312.

President of the Republic of Indonesia, “Presidential Regulation No. 112 of 2022 on the Acceleration of Renewable Energy Development for Electricity Supply,” State Secretariat, Jakarta, Indonesia, 2022. Available: https://peraturan.bpk.go.id/Details/225308/perpres-no-112-tahun-2022.

I. R. Naitio, A. Sanusi, P. Studi, and T. Mesin, “Analysis of wind potential as a driving source for Savonius wind turbines in Timor Tengah Selatan (TTS) Regency,” Lontar J. Mech. Eng., vol. 08, no. 01, pp. 71–75, 2021.

T. Ackermann and L. Söder, “Wind energy technology and current status: a review,” Renew. Sustain. Energy Rev., vol. 4, no. 4, pp. 315–374, 2000, doi: https://doi.org/10.1016/S1364-0321(00)00004-6.

M. Seify, H. Seifi, and E. L. Ntantis, “A comprehensive review on Savonius vertical-axis wind turbines: design advances and efficiency enhancement,” Energy Convers. Manag. X, vol. 30, p. 101830, 2026, doi: https://doi.org/10.1016/j.ecmx.2026.101830.

R. D. Hemrom and S. Sarkar, “Performance analysis of Savonius hydrokinetic turbine in array based at same input velocity at different speed,” Int. J. Adv. Technol. Eng. Sci., vol. 5, no. 4, pp. 507–513, 2017.

P. Mohan Kumar, M. M. R. Surya, S. Narasimalu, and T. C. Lim, “Experimental and numerical investigation of novel Savonius wind turbine,” Wind Eng., vol. 43, no. 3, pp. 247–262, 2019, doi: https://doi.org/10.1177/0309524X18780392.

H. R. N. Ramadhan, G. S. Lubis, M. Taufiqurrahman, A. D. Nugroho, and J. Jumiyanto, “Analysis of the effect of wind speed and overlap ratio on the performance of a U-type Savonius wind turbine,” J. Technol. Mech. Eng. Rev., vol. 6, no. 1, pp. 1–7, 2025.

M. Firman, “Improving the performance of an L-type Savonius wind turbine with overlap distance variations,” J. Engine Energy Manuf. Mater., vol. 8, no. 1, pp. 28–35, 2024.

I. K. Bachtiar, “The effect of blade overlap on the performance of Savonius wind turbine,” in Proc. Int. Conf. Electr. Eng. Comput. Sci., 2020, pp. 236–239.

K. Mrigua, M. Zemamou, and M. Aggour, “Numerical investigation of a new modified Savonius wind turbines,” Int. J. Renew. Energy Dev., vol. 11, no. 4, pp. 1113–1123, 2022, doi: https://doi.org/10.14710/ijred.2022.45799.

R. Sumiati, M. L. Artia, U. G. S. Dinata, A. Tasri, and Gusriwandi, “The effect of overlap ratio on a Savonius turbine model on the characteristics of the power coefficient based on wind tunnel experiments,” J. Mech. Eng., vol. 15, no. 2, pp. 153–158, 2022.

S. D., B. Ramadhan, and T. Yogi, “Experimental study on improving the performance of a Savonius wind turbine by placing a disturbing cylinder in front of the returning blade at S/D = 1.2,” J. Tech. ITS, vol. 9, no. 2, pp. 5–10, 2020.

S. Tayari, O. Toumi, and R. Ennetta, “Effect of endplates and aspect ratio performance of a Savonius wind turbine,” E3S Web Conf., vol. 697, p. 00024, 2026, doi: https://doi.org/10.1051/e3sconf/202369700024.

I. O. Silla, A. Sanusi, and Y. M. Pell, “Performance analysis of a Savonius turbine as an alternative energy source,” J. Phys. Phys. Sci. Appl., vol. 7, no. 1, pp. 64–68, 2022.

M. A. Kamoji, S. B. Kedare, and S. V. Prabhu, “Experimental investigations on the effect of overlap ratio and blade edge conditions on the performance of conventional Savonius rotor,” Wind Eng., vol. 32, no. 2, pp. 163–178, 2008, doi: https://doi.org/10.1260/030952408784815468.

M. Mohammed, S. Sarip, and A. Aziz, “CFD-based performance optimization of overlap ratio in Savonius hydrokinetic turbines for riverine energy systems,” Chem. Eng. Trans., vol. 122, pp. 259–264, 2025, doi: https://doi.org/10.3303/CET25122044.

V. A. Manavar, “Design optimization of Savonius wind turbine using CFD simulations,” M.S. thesis, Gujarat Technological University, India, 2021. Available: https://acrobat.adobe.com/id/urn:aaid:sc:AP:454d602a-369b-451e-a3f9-dbf6b6540fc1.

J. V. Akwa, G. Alves, and A. P. Petry, “Discussion on the verification of the overlap ratio influence on performance coefficients of a Savonius wind rotor using computational fluid dynamics,” Renew. Energy, vol. 38, no. 1, pp. 141–149, 2012, doi: https://doi.org/10.1016/j.renene.2011.07.013.

J. Ramarajan and S. Jayavel, “Numerical study on the effect of out-of-phase wavy confining walls on the performance of Savonius rotor,” J. Wind Eng. Ind. Aerodyn., vol. 226, p. 105023, 2022, doi: https://doi.org/10.1016/j.jweia.2022.105023.

A. Sharifian, “Influence of blade overlap and blade angle on the aerodynamic coefficients in vertical axis swirling type Savonius wind turbine,” Int. J. Adv. Renew. Energy Res., vol. 1, no. 4, pp. 1–8, 2014.

A. M. N. Elmekawy, H. A. H. Saeed, and S. Z. Kassab, “Performance enhancement of Savonius wind turbine by blade shape and twisted angle modifications,” Proc. Inst. Mech. Eng. Part A J. Power Energy, vol. 235, no. 6, pp. 1487–1500, 2021, doi: https://doi.org/10.1177/0957650920987942.

I. Marinić-Kragić, D. Vučina, and Z. Milas, “Computational analysis of Savonius wind turbine modifications including novel scooplet-based design attained via smart numerical optimization,” J. Clean. Prod., vol. 262, p. 121310, 2020, doi: https://doi.org/10.1016/j.jclepro.2020.121310.

D. Thomas and S. Brown, “Influence of blade overlap ratio on the aerodynamic performance of a single-stage Savonius vertical-axis wind turbine,” Acad. Res. Pap., pp. 1–12, 2024.

R. Sumiati, M. L. Artia, U. G. S. Dinata, and Gusriwandi, “The effect of overlap ratio on a Savonius turbine model on the characteristics of the power coefficient based on wind tunnel experiments,” J. Mech. Eng., vol. 15, no. 2, pp. 153–158, 2022.

A. M. N. Elmekawy and H. A. H. Saeed, “Performance enhancement of Savonius wind turbine by blade shape and twisted angle modifications,” Proc. Inst. Mech. Eng. Part A J. Power Energy, vol. 235, no. 6, 2021, doi: https://doi.org/10.1177/0957650920987942.

S. Shahriare, M. R. Rony, and P. Das, “Enhanced aerodynamic performance of Savonius wind turbines through blade design modifications: a CFD study,” Wind Energy, vol. 28, no. 8, pp. 1–13, 2025, doi: https://doi.org/10.1002/we.70042.

S. Sudirman and H. Santoso, “The effect of wind guide and wind speed on a three-blade Savonius turbine on the electrical energy generated,” Eng. J. Sci. Technol., vol. 16, no. 02, pp. 255–260, 2020.

S. Sudirman, S. Kurniati, and A. M. I. A. Arifin, “Analysis of wind power plants using Savonius turbines,” J. Media Elektro, vol. IX, no. 1, pp. 1-8, 2020.

PlumX Metrics

Published
2026-10-30
How to Cite
[1]
N. Afni, S. Syam, and S. Kurniati, “STUDY OF BLADE OVERLAP VARIATION ON THE POWER COEFFICIENT, TORQUE, AND TSR OF A SAVONIUS TURBINE FOR THE LOW-WIND-SPEED REGION OF NTT”, JME, pp. 96 - 105, Oct. 2026.
Section
Articles