USULAN PERBAIKAN KUALITAS PRODUK TOPSIDE MENGGUNAKAN METODE FMEA DI PT. XYZ
-
Rahmawati Berlyan(1*)
Jurusan Teknik Industri Universitas Trisakti
-
Wawan Kurniawan(2)
Jurusan Teknik Industri Universitas Trisakti
-
Indah Permata Sari(3)
Jurusan Teknik Industri Universitas Trisakti
(*) Corresponding Author
Abstract
XYZ is a company engaged in fabrication. Quality is very important for the company because it can affect customer satisfaction. In the production process there are still defect problems found on the top side of the structural construction and it affects the quality of the part. The failure rate on the topside product has a 5:28% percentage exceeds the standards set by the company which is 2%. Based on the percentage of defects that have been obtained, the problem can be solved by fishbone analysis and FMEA. In the first stage using CTQ which aims to identify failures that occur and determine quality characteristics. The next step after identifying the failure that occurred can be calculated DPMO and Sigma Level. After getting the DPMO value and the Sigma level, identification of the root causes of the failure occurred. The causes of problems that have been analyzed using fishbone analysis can be solved using FMEA.
Keywords : DPMO, Tingkat Sigma, Fishbone analysis, FMEA
Downloads
References
H. Bonar, P. Luthfi, and A. L. F. An. (2018). “Analisis Pengendalian Kualitas dengan Menggunakan Metode Six Sigma ( Studi Kasus : PT. Growth Sumatra Industry ),” J. Bul. Utama Tek., vol. 13, no. 3, pp. 211–219, 2018
M.- Imtihan and R. Revino. (2019). “Redesign Alat Tambahan Pada Mesin Produksi Komponen Otomotif Body Inner Dalam Meningkatkan Kualitas Melalui Strategi Dmaic,” J. Ind. Eng. Manag., vol. 4, no. 1, p. 9, 2019, doi: 10.33536/jiem.v4i1.125.
A. G. Arsyad, P. F. Ferdinant, and R. Ekawati. (2017) “Analisis Peta Kendali p yang Distandarisasi dalam Proses Produksi Regulator Set Fujiyama (Studi Kasus : PT . XYZ),” J. Tek. Ind., vol. 5, no. 1, pp. 86–92, 2017.
M. W. Wardhana and E. Adi. (2018). “Pengolahan Produk Minyak Sawit Dengan Pendekatan Statistical Quality Control ( Sqc ),” J. Rekayasa, Teknol. dan Sains, vol. 2, pp. 27–34, 2018.
C. E. Widyahening. (2018) “Penggunaan Teknik Pembelajaran Fishbone Diagram Dalam Meningkatkan Keterampilan Membaca Siswa,” J. Komun. Pendidik., vol. 2, no. 1, p. 11, 2018, doi: 10.32585/jkp.v2i1.59.
R. Y. Hanif, H. S. Rukmi, and S. Susanty. (2015) “Perbaikan Kualitas Produk Keraton Luxury di PT.X dengan Menggunakan Metode Failure Mode and Effect Analysis (FMEA) dan Fault Tree Analysis (FTA),” J. Online Inst. Teknol. Nas. Juli, vol. 03, no. 03, pp. 137–147, 2015.
